The Cirrus Logic EP7212 Development Board is almost identical to the EP7211 Development Board from a hardware setup viewpoint, and is based on the same port of eCos. Therefore the earlier documentation for the EP7211 Development Board can be considered equivalent, but with the following changes:
The first serial port is silk screened as "UART 1" on the EP7211 Development Board, but is silk screened as "Serial Port 0" on the EP7212 Development Board. Similarly "UART 2" is silk screened as "Serial Port 1" on the EP7212 Development Board.
JP2 (used to control reprogramming of the FLASH) is not silkscreened with "Boot Enable".
To setup the EP7212 Development Board for use with the ARM Multi-ICE JTAG debugging interface unit, it is necessary to connect TEST0 and TEST1 of the EP7212 to ground. On the Development Board, this is accomplished by placing shorting blocks on JP47 and JP48. When the shorting blocks are fitted, the board can only be operated through the Multi-ICE - debugging over a serial line is not possible.
Pre-built GDB stubs are provided in the directory loaders/arm-edb7212 relative to the root of your eCos installation
When rebuilding the GDB stub ROM image, change the "Cirrus Logic processor variant" option (CYGHWR_HAL_ARM_EDB7XXX_VARIANT) from the EP7211 to the EP7212. This can be selected in the eCos Configuration Tool , or if using ecosconfig, can be set by uncommenting the user_value property of this option in ecos.ecc and setting it to "EP7212".