MIBs supported

The standard set in MIB-II, together with the Ether-Like MIB, are supported by default. The MIB files used to compile the handlers in the agent and to “drive” the testing (snmpwalk et al under LINUX) are those acquired from that same UCD distribution.

These are the supported MIBs; all are below mib2 == 1.3.6.1.2.1:

system        { mib2 1 }   
interfaces    { mib2 2 }
              [ address-translation “at” { mib2 3 } is deprecated ]
ip            { mib2 4 }   
icmp          { mib2 5 }   
tcp           { mib2 6 }   
udp           { mib2 7 }
              [ exterior gateway protocol “egp” { mib2 8 } not supported ]
              [ cmot { mib2 9 } is “historic”, just a placeholder ]
dot3          { mib2 10 7 } == { transmission 7 } “EtherLike MIB”
snmp          { mib2 11 }

On inclusion of SNMPv3 support packages, the following MIBs are added to the default set of MIBs enumerated above :

snmpEngine    { snmpFrameworkMIBObjects 1 }  SNMP-FRAMEWORK-MIB, as described in
                                             RFC-2571 for support of SNMPv3
                                             framework.

usmStats      {           usmMIBObjects 1 }  SNMP-USER-BASED-SM-MIB, as 
usmUser       {           usmMIBObjects 2 }  specified in RFC-2574 for support 
                                             of user based security model in 
                                             SNMPv3 management domains.