Initializing the USB-ethernet Package

Name

usbs_eth_init -- Initializing the USB-ethernet Package

Synopsis

#include <cyg/io/usb/usbs_eth.h>

void usbs_eth_init(usbs_eth* usbeth, usbs_control_endpoint* ep0, usbs_rx_endpoint* ep1, usbs_tx_endpoint* ep2, unsigned char* mac_address);

Description

The USB-ethernet package is not tied to any specific hardware. It requires certain functionality: there must be USB-slave hardware supported by a device driver; there must also be two endpoints for bulk transfers between host and peripheral, one for each direction; there must also be a control endpoint, although of course that is implicit with any USB hardware.

However, USB-slave hardware may well provide more endpoints than the minimum required for ethernet support. Some of those endpoints might be used by other packages, while other endpoints might be used directly by the application, or might not be needed for the peripheral being built. There is also the possibility of a USB peripheral that supports multiple configurations, with the ethernet support active in only some of those configurations. The USB-ethernet package has no knowledge about any of this, so it relies on higher-level code to tell it which endpoints should be used and other information. This is the purpose of the usbs_eth_init function.

The first argument identifies the specific usbs_eth data structure that is affected. It is expected that the vast majority of affected applications will only provide a single USB-ethernet device to a single host, and the package automatically provides a suitable data structure usbs_eth0 to support this. If multiple usbs_eth structures are needed for some reason then these need to be instantiated by other code, and each one needs to be initialised by a call to usbs_eth_init().

The next three arguments identify the endpoints that should be used for USB communications: a control endpoint, a receive endpoint for ethernet packets coming from the host to the peripheral, and a transmit endpoint for ethernet packets going in the other direction. Obviously all three endpoints should be provided by the same USB hardware. The USB-ethernet package assumes that it has sole access to the receive and transmit endpoints, subject to the use of usbs_eth_disable and usbs_eth_enable control functions. The package also assumes that no other code is interested in USB state changes or class control messages: it installs handlers usbs_eth_state_change_handler and usbs_eth_class_control_handler in the control endpoint. If any other code does need to handle USB state changes or class control messages then replacement handlers should be installed after the call to usbs_eth_init, and those replacements should invoke the USB-ethernet ones when appropriate.

The final argument to usbs_eth_init specifies the MAC address (or Ethernet Station Address) that should be provided to the host-side device driver. Since the USB-ethernet package does not interact directly with a real ethernet device it cannot obtain the MAC address from any hardware. Instead, it must be supplied by higher-level code. The details depend on the scenario in which the USB-ethernet package is being used.

The call to usbs_eth_init should normally happen after the enumeration data has been provided but before the underlying USB device driver has been started. If the USB device were to be started first then a connection between host and peripheral could be established immediately, and the host-side device driver would attempt to contact the USB-ethernet package for information such as the MAC address.

int
main(int argc, char** argv)
{
    unsigned char host_MAC[6] = { 0x40, 0x5d, 0x90, 0xa9, 0xbc, 0x02 };

    usbs_sa11x0_ep0.enumeration_data    = &usb_enum_data;
    …
    usbs_eth_init(&usbs_eth0, &usbs_sa11x0_ep0, &usbs_sa11x0_ep1, &usbs_sa11x0_ep2, host_MAC);
    …
    usbs_start(&usbs_sa11x0_ep0);
    …
}