This is the mail archive of the
ecos-bugs@sourceware.org
mailing list for the eCos project.
[Bug 1001397] I2C driver for Kinetic microcontrollers
- From: bugzilla-daemon at bugs dot ecos dot sourceware dot org
- To: unassigned at bugs dot ecos dot sourceware dot org
- Date: Sat, 24 Dec 2011 09:21:58 +0000
- Subject: [Bug 1001397] I2C driver for Kinetic microcontrollers
- Auto-submitted: auto-generated
- References: <bug-1001397-777@http.bugs.ecos.sourceware.org/>
Please do not reply to this email. Use the web interface provided at:
http://bugs.ecos.sourceware.org/show_bug.cgi?id=1001397
--- Comment #7 from Tomas Frydrych <tf+bugs.ecos@r-finger.com> 2011-12-24 09:21:52 GMT ---
(In reply to comment #5)
> As there is existing devs/i2c directory, I propose following path:
> - devs/i2c/freescale/<freescale_i2c>
OK, but the situation is exactly the same for the SLCD controller, and so we
end up with bits under devs/ and bits under hal/misc, with no clear logic for
the distinction I can see.
> where <freescale_i2c> is the name of this particular freescale spi instance
> (typically as referred to in ref. man.).
The services have only generic names in the Freescale RMs, so we end up with
very generic names. That is fine if Freescale only make a single i2c controller
and never will design another one, perhaps that is the case?
--
Configure bugmail: http://bugs.ecos.sourceware.org/userprefs.cgi?tab=email
------- You are receiving this mail because: -------
You are the assignee for the bug.