This is the mail archive of the
mailing list for the eCos project.
[Bug 1001397] I2C driver for Kinetic microcontrollers
- From: bugzilla-daemon at bugs dot ecos dot sourceware dot org
- To: ecos-bugs at ecos dot sourceware dot org
- Date: Tue, 25 Dec 2012 21:33:41 +0000
- Subject: [Bug 1001397] I2C driver for Kinetic microcontrollers
- Auto-submitted: auto-generated
- References: <email@example.com/>
Please do not reply to this email. Use the web interface provided at:
--- Comment #30 from Ilija Kocho <firstname.lastname@example.org> 2012-12-25 21:33:38 GMT ---
Hi Mike, thank you for your considerations.
(In reply to comment #28)
> I can make a couple of comments based on my experience with K60 and the
> Freescale POSIX I2C driver and a real application.
> First is the issue of using the interrupt driver vs polling driver. I use the
> interrupt driver so that other tasks can operate while waiting. My application
> is PMBus, and clock stretching can slow things down, so I figure I don't want
> to be in a polling loop.
Polling is not an issue with eCos I2C driver. It is interrupt driven indeed.
My question is about the macro WAIT_BUS_READY() and my concern is for
multi-master system since, in a single master system it is returns immediately.
Perhaps you could give it a try in your environment. Any feedback is
Configure bugmail: http://bugs.ecos.sourceware.org/userprefs.cgi?tab=email
------- You are receiving this mail because: -------
You are on the CC list for the bug.