This is the mail archive of the
ecos-discuss@sourceware.cygnus.com
mailing list for the eCos project.
Motorola MPC8xxFADS board and BDM
- To: "'eCos discussion mailing list'" <ecos-discuss at sourceware dot cygnus dot com>
- Subject: [ECOS] Motorola MPC8xxFADS board and BDM
- From: "John Fisher" <jfisher at tns dot neca dot nec dot com dot au>
- Date: Wed, 27 Oct 1999 16:33:18 +1000
- Reply-To: <jfisher at tns dot neca dot nec dot com dot au>
I believe it should be possible to get eCos going on this board using the
BDM debug port and the Macraigor wiggler and without using an externally
burnt flash or the gdb stub or MPC8BUG and the ADI card.
I'm thinking along the lines of using a gdb script to get things going,
starting with
target ocd wiggler lpt1
then configuring the memory controller sufficiently to get to the point
where I can download eCos + application and then let it rip.
Am I thinking along plausible lines? If so has anyone already done this? If
not any advice along the lines of what needs to be done would be
appreciated.
I'm thinking I'll need to at least write the gdb script and modify one of
the existing platform ports (not sure which one is best) to suit the
situation. I could also perhaps start with the Motorola example startup
code.
John Fisher
Transmission Systems Division
NEC Australia Pty Ltd
649 Springvale Road
Mulgrave Vic 3170
Australia
email: jfisher@tns.neca.nec.com.au
ph: + 613 9264 3606
fax: + 613 9264 3892