This is the mail archive of the
ecos-discuss@sourceware.cygnus.com
mailing list for the eCos project.
BreakPoint problems !!
- To: eCos-Discuss Mailing List <ecos-discuss at sourceware dot cygnus dot com>
- Subject: [ECOS] BreakPoint problems !!
- From: "P.Mahendra Babu" <babu at cdotb dot ernet dot in>
- Date: Wed, 23 Feb 2000 17:14:04 +0500 (GMT+0500)
Hello Everybody,
We have downloaded ecos-SW tools for Linux and
installed the tools for target powerpc-eabi.
We use MBX860 board and have successfully fused
stubrom for startup.
Now, when we make programs, we are successfully
able to download and run them. We are able to
set more than one breakpoints but, only the
first one is hit. After the first breakpoint is
hit, there is no control... i.e., it doesn't stop
in further breakpoints. Even step, next commands
do not seem to work. Program just continues until
exit point irrespective of the command given(step,
next or continue..) What is the problem ?
Does anybody else have the same problem ? Or the
gdb stubs can handle only one breakpoint now ?
When I list the breakpoints using "maintenance
info breakpoints", all breakpoints are alive even
after the first breakpoint is hit.
Hope to receive a solution faaaaaaaaast.
thanx in advance,
Babu
\\\|///
\\ _ _ //
( @ @ )
¤----------------------------------------oOOo-(_)-oOOo----------------¤
¤ Mahendra Babu P. , ¤
¤ Research Engineer, Phone : +91-080-5510086 ¤
¤ C-DOT, Fax : +91-080-2263256 ¤
¤ Sneha Complex, Email : babu@cdotb.ernet.in ¤
¤ 71/1, Millers Road, pmbabu@yahoo.com ¤
¤ Bangalore - 560 052, India. URL : http://i.am/pmbabu ¤
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~