This is the mail archive of the
ecos-discuss@sourceware.cygnus.com
mailing list for the eCos project.
Re: MBX Stub
- To: amassa at cts dot com
- Subject: [ECOS] Re: MBX Stub
- From: Jonathan Larmour <jlarmour at redhat dot co dot uk>
- Date: Mon, 05 Jun 2000 18:09:59 +0100
- CC: jlarmour at cygnus dot co dot uk, ecos-discuss at sourceware dot cygnus dot com
- Organization: Red Hat UK Ltd.
- References: <000001bfcd97$3e1061c0$0c0cbcc0@machine1dsktp.cts.com>
Anthony Massa wrote:
>
> I built the MBX board stub using just the stub template.
You could try using the prebuilt image in the "loaders" subdir of your eCos
installation.
> I then followed
> the directions to program the srec stub into flash. Now I am trying to
> establish communication with the stub via my COM2 serial port on my PC.
> However, I have had no success at doing this. I tried running the tests
> from the ecos configuration tool as well and I get the same response:
>
> couldn't establish connection with remote target.
>
> Do you know what I could try or if I should check somethings that I might be
> doing wrong?
Check whether the stub is alive using a terminal (hyperterminal on windows,
minicom on linux). When the board resets you should see some output. This
is at 38400bps 8-N-1. Check you followed the other instructions in the
"hardware setup" section in the docs.
Jifl
--
Red Hat, 35 Cambridge Place, Cambridge, UK. CB2 1NS Tel: +44 (1223) 728762
"Plan to be spontaneous tomorrow." || These opinions are all my own fault