This is the mail archive of the
ecos-discuss@sources.redhat.com
mailing list for the eCos project.
Re: question of Gdbstub for NECVR4373 board
- To: bartv at redhat dot com
- Subject: Re: [ECOS] question of Gdbstub for NECVR4373 board
- From: Jonathan Larmour <jlarmour at redhat dot co dot uk>
- Date: Wed, 02 Aug 2000 19:21:01 +0100
- CC: lingsu at palmmicro dot com, ecos-discuss at sources dot redhat dot com, julians at cygnus dot co dot uk
- Organization: Red Hat UK Ltd.
- References: <008301bffca7$fd432fc0$0201a8c0@raccoon> <200008021802.TAA21841@sheesh.cygnus.co.uk>
Bart Veer wrote:
>
> Ling> <3>. I found a minor buggy point of the eCos Configure
> Ling> tools, even I change the configuration of gdb serial speed
> Ling> to 9600B, when I run tests, it still "set remotebaud 38400".
> Ling> I feel it will be more convenient if this can be consistent
> Ling> with what I configured.
>
> The various host-side tools (configtool, gdb, ...) have been developed
> independently. At some point they may start interacting via e.g. a
> CORBA backplane, and things like setting the baud rate correctly will
> just work. I have no idea when anything like that is likely to happen.
>
> Of course gdb is used for many different systems, not just eCos. It
> cannot be changed in ways that will affect the ability to debug other
> systems.
I think Ling was referring to the "Run Tests" functionality - it runs GDB
and passes the baud rate in. Perhaps John/Julian can confirm this and have
a look.
[ Julian, are you subscribed to ecos-discuss yet? If not, you should be
:-). ]
Jifl
--
Red Hat, 35 Cambridge Place, Cambridge, UK. CB2 1NS Tel: +44 (1223) 728762
"Plan to be spontaneous tomorrow." || These opinions are all my own fault