This is the mail archive of the
ecos-discuss@sources.redhat.com
mailing list for the eCos project.
Re: network support
- To: Fano Ramparany <Fano dot Ramparany at rd dot francetelecom dot fr>
- Subject: Re: [ECOS] network support
- From: Gary Thomas <gthomas at cambridge dot redhat dot com>
- Date: Tue, 30 Jan 2001 05:33:49 -0700 (MST)
- Cc: eCos Disuss <ecos-discuss at sourceware dot cygnus dot com>
- Organization: Red Hat, Inc.
On 30-Jan-2001 Fano Ramparany wrote:
> I then had a look at the configuration file.
> Below is the part of the "ecc" file related the network
> drivers. All variables related to the NET_DRIVERS are assigned
> a 0 value.
> In the (Windows NT) eCos Configuration Tool, the items Initialization
> options for 'eth0', are greyed out, and thus can't be
> modified.
> Do you have any hint about what I'm doing wrong?
>
This is definitely your problem. Did you create this configuration
from scratch? I just tried this, starting fresh, selecting the
Cirrus Logic development board + "net" template - AT ONE TIME - and
it came out perfectly.
Build->Templates->Hardware = Cirrus Logic Development Board
Packages = net
What sources are you building from? If non anonCVS, then you might
consider trying that.
Here's an excerpt [from the same point as yours]:
# <
# Network drivers
#
cdl_interface CYGHWR_NET_DRIVERS {
# Implemented by CYGPKG_DEVS_ETH_ARM_EDB7XXX, active, enabled
# This value cannot be modified here.
# Flavor: data
# Current_value: 1
# The following properties are affected by this value
# component CYGPKG_NET_DHCP
# ActiveIf: (CYGHWR_NET_DRIVERS > 0)
};
# Does the hardware provide an 'eth0' device?
#
cdl_interface CYGHWR_NET_DRIVER_ETH0 {
# Implemented by CYGPKG_DEVS_ETH_ARM_EDB7XXX, active, enabled
# This value cannot be modified here.
# Flavor: data
# Current_value: 1
# The following properties are affected by this value
# component CYGHWR_NET_DRIVER_ETH0_SETUP_OPTIONS
# ActiveIf: (CYGHWR_NET_DRIVER_ETH0 == 1)
};