This is the mail archive of the
ecos-discuss@sources.redhat.com
mailing list for the eCos project.
RE: How to control where diag_printf() output goes?
- To: <ecos-discuss at sources dot redhat dot com>
- Subject: RE: [ECOS] How to control where diag_printf() output goes?
- From: "Andy Simpkins" <Andy dot Simpkins at TardisMobile dot com>
- Date: Tue, 27 Mar 2001 09:59:08 +0100
- Reply-To: Andy dot Simpkins at TardisMobile dot com
Haven't had need to change it but I believe that it is
Diagnostic serial port found on the cdl script for the platform
in my case ARM architecture -> ARM Tardis3 -> Diagnostic serial port
but then again I could be talking out my backside :-)
Andy
-----Original Message-----
From: ecos-discuss-owner@sources.redhat.com
[mailto:ecos-discuss-owner@sources.redhat.com]On Behalf Of Grant Edwards
Sent: 27 March 2001 01:36
To: ecos-discuss@sources.redhat.com
Subject: [ECOS] How to control where diag_printf() output goes?
I can't figure out how to set the diag channel used for
diagnostic output by diag_printf(). Can somebody give me a
hint?
--
Grant Edwards
grante@visi.com