This is the mail archive of the
ecos-discuss@sources.redhat.com
mailing list for the eCos project.
Re: odd serial input bug in redboot 095308 20010607 on iP
On Fri, Jun 08, 2001 at 11:03:14AM -0600, Gary Thomas wrote:
>
> The screen flicker is a hardware problem. Since RedBoot is executing from Flash,
> certain patterns can saturate the memory bus which causes the LCD to flicker.
Ok.
> > Curioser and curiouser. If I upload the compressed version with load -d, it
> > complains of a CRC error. If I upload the uncompressed version and go 0x20040,
> > I get '$T050f:4c000200;0d:e4b80000;#79' and '$T050f:4c000200;0d:e4b80000;#79'
> > in response to every keystroke (alternately). Any clue what *that* is?
>
> Yes, this is GDB telling you that the program dies at location 0x0024c00 which
> as far as I can tell is somewhere in the NanoX initialization code. You can see
> more by disconnecting minicom/hyperterm and then connecting to the board via
> GDB.
> arm-elf-gdb -nw
> (gdb) tar rem /dev/ttyS0
> (gdb) info reg
>
> Did you also load the eCos ROM FS and install it? It may be the case that it
> was scrogged as well.
I don't have a gdb for arm/elf; I can probably install it over the weekend if
it would be useful (which it sounds like it would). I did not load the eCos
ROMFS; the web page indicates that it's only needed if you want to burn the
nanox demo to flash.
I've just installed ecosroms.gz and reinstalled nanoxdemo; same result.
I guess I'll have to wait until I get an arm/elf debugger set up?
I do wonder why it's giving me such trouble, though. I was under the
impression that this stuff was pretty extensively used.
Thanks,
david