This is the mail archive of the
ecos-discuss@sources.redhat.com
mailing list for the eCos project.
RE: Rebuilding RedBoot for EDB7212
- TO: ecos-discuss at sourceware dot cygnus dot com
- Subject: RE: [ECOS] Rebuilding RedBoot for EDB7212
- From: "Stefano Costa" <stefano dot costa at bluewind dot it>
- Date: Thu, 14 Jun 2001 15:42:32 +0100
- Organization: Bluewind
- References: <3B288C5E.17314.32A2F9@localhost>
- Reply-to: stefano dot costa at bluewind dot it
On 14 Jun 2001, at 4:26, Gary Thomas wrote:
<SKIP>
>
> > for EP7xxx. Flashing the image that I get with this build, it seems
> > that RedBoot is only able to connect with serial line and download
> > an application to RAM, but it has no Ethernet and FLASH support even
> > if the related checkboxes are highlighted in the ConfigTool. Did
> > anyone face the same problem?
>
> That's because you didn't include the drivers for any of these
> devices.
I'm using is the graphical Config Tool (1.3.1.2) for Windows; I
choose the "Cirrus Logic EDB7XXX" template, with the RedBoot
set of packages. Then I set EP7212 as a processor and ROM as a
startup enviroment. Examining the configuration, yes I noticed that
"Cirrus Logic ethernet driver" and "Cirrus Logic EDB7XXX FLASH
memory support" sections are greyed out, but I didn't find any
dependency to enable them. Why?
>
> Follow the instructions in the RedBoot manual for rebuilding:
>
> % ecosconfig new edb7212 redboot
> % ecosconfig import
> ${ECOS_REPOSITORY}/hal/arm/edb7xxx/current/misc/edb7212_redboot_ROM.
> ecm % ecosconfig tree % make
>
>
So, should I build RedBoot only from command line, and not from
the graphical tool?
bye- Stefano
-----------------------------------------
BlueWind Electronic Design
I-31033 Castelfranco Veneto (TREVISO)
Via Steffani 7/B
-----------------------------------------
VOICE +39 0 423 723431
FAX +39 0 423 744738
MOBILE +39 335 6565749
http://www.bluewind.it
-----------------------------------------