This is the mail archive of the
ecos-discuss@sources.redhat.com
mailing list for the eCos project.
Re: RE: error connecting to GDB.. (need some more..help)
- To: Sateesh Soman <sateesh_soman at rediffmail dot com>
- Subject: [ECOS] Re: RE: error connecting to GDB.. (need some more..help)
- From: Gary Thomas <gthomas at cambridge dot redhat dot com>
- Date: Tue, 03 Jul 2001 07:18:17 -0600 (MDT)
- Cc: "ecos-discuss at sources dot redhat dot com" <ecos-discuss at sources dot redhat dot com>
- Organization: Red Hat, Inc.
On 03-Jul-2001 Sateesh Soman wrote:
> Hi,
> I wasn't able to type the '$' itself. My target doesn't repond after that.
> I'll try with slower baud rates and let you know.
Read what I said carefully - you will not see _any_ response from the target
after you type the '$', until you have typed the whole thing.
>
> Sateesh.
>
> ------------- Original Message --------------
> Gary Thomas <gthomas@cambridge.redhat.com> wrote:
> Subject: RE: error connecting to GDB.. (need some more..help)
>
>
> On 03-Jul-2001 Sateesh Soman wrote:
>> Hi,
>> I have a similar problem of connecting to the target through GDB using serial.
> .
> .
> .
> .
> .
>
>> I am using V2.0.2 ConfigTool with latest eCos package (dt: 28-06-01) and my target is a PC. Host
>> is running WinNT. I have built redboot with importing floppy.ecm.
>>
>
> Try connecting via hyperterm and typing '$Hc-1#09' by hand. You should get
> something like this: +$OK#9a (Note, you won't seen anything until the '+'
> comes back). If this works when typed slowly, I would think that your target
> can't keep up with data at 38400 when it comes in bursts. If that is the
> case, then you could try rebuilding RedBoot for the target to run GDB at a
> slower baudrate.
>
>
> ____________________________________________________
> Buy Feng Shui Package for Rs. 151/- only, at
> http://shopping.rediff.com/shopping/fengshui_mailer.htm
>