This is the mail archive of the
ecos-discuss@sources.redhat.com
mailing list for the eCos project.
ASSERTS & TRACING quit working
- To: "'eCos discussion'" <ecos-discuss at sources dot redhat dot com>
- Subject: [ECOS] ASSERTS & TRACING quit working
- From: "Trenton D. Adams" <tadams at extremeeng dot com>
- Date: Wed, 11 Jul 2001 10:27:26 -0600
- Organization: Extreme Engineering
I had to make a new eCos build because I screwed my old one up. So,
I've got everything setup, and my program is working, but ASSERTS &
TRACING are not working. I enabled them both in the eCos config tool
1.3.1.2, but for some reason I'm not getting any tracing output from my
functions. The only place I enabled them at was in the "Infrastructure"
section. Do I have to enable them some where else too?