This is the mail archive of the
ecos-discuss@sources.redhat.com
mailing list for the eCos project.
Re: Hardware Watchdog
On Fri, Jul 27, 2001 at 08:48:14AM +0200, Robin Farine wrote:
> Ok, have you already tried to configure the GPIO pin as *input*? This would
> set the line in high-impedance mode and the MAX should disable its watchdog
> function. Check your ROM startup code for access to the GPDR (IO direction
> register). Then, in the application, reconfigure this bit as output to use the
> watchdog.
basically its right, but the hardware designers
made a good job of it, and there is a pull down
resistor preventing the watchdog input from floating.
(which would disable the watchdog timer)
i dont think the soldering iron is an acceptable
solution. :-)
thanks, christoph
-