RE: [ECOS] Port to XScale board

[Cristiano Ligieri Pereira <cpereira at ics dot uci dot edu>]

It's Linux. I'll try minicom. 

The 'C' characters come out around 3 seconds apart. The Delay is OK.

Cristiano.

------------------------------------------------------------
Cristiano Ligieri Pereira - http://www.ics.uci.edu/~cpereira

> What's your development platform?  Can you use 'minicom' (we've had no
> troubles with it).
> 
> What happens if you run 'load' from RedBoot, but _don't_ disconnect?
> You should get a series of 'C' characters, each about 3 seconds apart.
> If they all come out right off, then you need to look at your implementation
> of HAL_DELAY_US().  This is also a common problem for new ports.
>