This is the mail archive of the
ecos-discuss@sources.redhat.com
mailing list for the eCos project.
Re: About TCP/IP for ARM E7T
- To: "Tim Michals" <Tim dot Michals at Cygnetinc dot com>
- Subject: Re: [ECOS] About TCP/IP for ARM E7T
- From: "Chris Garry" <cgarry at mail dot portland dot co dot uk>
- Date: Tue, 16 Oct 2001 14:50:32 +0100
- Cc: "eCos" <ecos-discuss at sources dot redhat dot com>
- Organization: Sweeney Design
- References: <63A6C537769693488EF351F5DB94668615B436@cyglew04.cygnetinc.com>
- Reply-To: "Chris Garry" <cgarry at mail dot portland dot co dot uk>
The board does not have a MII connector, instead the MII signals
go to a 50-pin connector (not fitted).
----- Original Message -----
From: "Tim Michals" <Tim.Michals@Cygnetinc.com>
Cc: "eCos" <ecos-discuss@sources.redhat.com>
Sent: Tuesday, October 16, 2001 2:18 PM
Subject: RE: [ECOS] About TCP/IP for ARM E7T
> Does this board have a MII connector?
>
> -----Original Message-----
> From: Chris Garry [mailto:cgarry@mail.portland.co.uk]
> Sent: Tuesday, October 16, 2001 8:19 AM
> To: HuangQiang
> Cc: eCos
> Subject: Re: [ECOS] About TCP/IP for ARM E7T
>
>
> It is not just the network connector that is missing, the ARM E7T
> requires a complete Ethernet PHY before it can be used. Does
> anybody know if somebody makes a small daughter-board for the E7T
> with the PHY and connector so that the network interface provided
> by the Samsung processor may be used?
>
> Chris
>
> ----- Original Message -----
> From: "Jesper Skov" <jskov@redhat.com>
> To: "HuangQiang" <jameshq@liverpool.ac.uk>
> Cc: "eCos" <ecos-discuss@sources.redhat.com>
> Sent: Tuesday, October 16, 2001 1:17 PM
> Subject: Re: [ECOS] About TCP/IP for ARM E7T
>
>
> > >>>>> "HuangQiang" == HuangQiang <jameshq@liverpool.ac.uk> writes:
> >
> > HuangQiang> Hi all: Does the TCP/IP stack in eCOS support the ARM E7T
> > HuangQiang> board? Thanks
> >
> > No. The one on my desk does not have the necessary connector. But it's
> > definitely possible to add the support.
> >
> > JEsper
> >
>