This is the mail archive of the
ecos-discuss@sources.redhat.com
mailing list for the eCos project.
Re: guide for running eCos in ARM PID
- From: "Young Jay" <young_jay at sohu dot com>
- To: "Jonathan Larmour" <jifl at eCosCentric dot com>
- Cc: <ecos-discuss at sources dot redhat dot com>
- Date: Mon, 16 Jun 2003 13:44:26 +0800 (CST)
- Subject: Re: [ECOS] guide for running eCos in ARM PID
Hello, Jonathan:
I just followed the instructions from http://sources.redhat.com/ecos/docs-latest/user-guide/setup-arm-pid.html,
but when I progressed to make redboot written into the Flash on PID board, I got an error message as follows:
"$ arm-elf-gdb -nw gdb_module.img
GNU gdb 5.3 (eCosCentric)
Copyright 2002 Free Software Foundation, Inc.
GDB is free software, covered by the GNU General Public License, and you are
welcome to change it and/or distribute copies of it under certain conditions.
Type "show copying" to see the conditions.
There is absolutely no warranty for GDB. Type "show warranty" for details.
This GDB was configured as "--host=i686-pc-cygwin --target=arm-elf"...
(no debugging symbols found)...
(gdb) target rdi s=com1
RDI_open: undefined error message, should reset target
RDI_open failed
(gdb) "
My board is properly powered up and I have connected it with a serial cable to
the host computer. Also I made correct jumper and switch set referring to the user
guide for PID board. But it seems that the communucation channel hasn't been
established. Could you tell me if there is still something to be configured in order
to program redboot with ROM startup mode into the flash on board? Thanks a lot!
Best regards,
Young Jay
----- Original Message -----
From: Jonathan Larmour
To: Young Jay
Cc: ecos-discuss@sources.redhat.com
Subject: Re: [ECOS] guide for running eCos in ARM PID
Sent: Fri Jun 13 12:30:06 CST 2003
> Young Jay wrote:
> > Hello, all:
> >
> > Could you tell me where to get a specific guide for running eCos
> > applications in ARM Development Board (PID), for my guide available is
> > old, in which cygmon and ARM SDT is used. Thank you!
>
> The eCos documentation!
>
> Load redboot: <http://ecos.sourceware.org/ecos/docs-latest/ref/pid.html>
>
> Then run eCos apps as per the generic documentation.
>
> Jifl
> --
> eCosCentric http://www.eCosCentric.com/ The eCos and RedBoot experts
> --[ "You can complain because roses have thorns, or you ]--
> --[ can rejoice because thorns have roses." -Lincoln ]-- Opinions==mine
>
--
Before posting, please read the FAQ: http://sources.redhat.com/fom/ecos
and search the list archive: http://sources.redhat.com/ml/ecos-discuss