This is the mail archive of the
ecos-discuss@sources.redhat.com
mailing list for the eCos project.
Redboot run problem on Malta-4kc
- From: "" <pyw02 at mails dot tsinghua dot edu dot cn>
- To: ecos-discuss at sources dot redhat dot com
- Date: Fri, 28 May 2004 11:26:08 +0800
- Subject: [ECOS] Redboot run problem on Malta-4kc
- Reply-to: "" <pyw02 at mails dot tsinghua dot edu dot cn>
hi, everyone
I'm trying to load redboot rom mode to Mips Malta-4kc board.
When this is complete, the LED display should show the last address
programmed. This will be something like: 1fc17000. But the display didn't
show address but just "dl_done".
then i reset the target, the display can show "RedBoot", but on the
minicom, it shows the following:
+IDE failed to identify unit 0 - wrote: a0, read: 0
IDE failed to identify unit 0 - wrote: b0, read: 0
IDE failed to identify unit 1 - wrote: a0, read: 0
IDE failed to identify unit 1 - wrote: b0, read: 0
FLASH configuration checksum error or invalid key
if i reset the board again, the messege will be shown again. Any input
cause no reponse. How could be that? Is there any configuration problem?
Any suggestions? thanks a lot.
--
Before posting, please read the FAQ: http://ecos.sourceware.org/fom/ecos
and search the list archive: http://ecos.sourceware.org/ml/ecos-discuss