[ECOS] Intel Strata Flash TE28F128J3 Problem.

[Annamalai Prakash <prakash at comodo dot com>]

Hi ,

              I wanted to bring up redboot with Intel's TE28F128J3C150 (256Mb) 
in my ixdp425 Board (ixp425 Xscale processor). I am using Intel Strata Flash 
driver which is integreated with ecos.  I am getting for Following output 
while board powerup/reset.

+FLASH configuration checksum error or invalid key
No network interfaces found

RedBoot(tm) bootstrap and debug environment [ROM]
Red Hat certified release, version 1.92 - built 14:54:46, Dec 30 2004

Platform: Interface Masters Kings Canyon 3 Board (XScale)
Copyright (C) 2000, 2001, 2002, Red Hat, Inc.

RAM: 0x00000000-0x04000000, 0x0006b090-0x01fd1000 available
FLASH: 0x50000000 - 0x51000000, 128 blocks of 0x00020000 bytes each.
RedBoot>

                 PROBLEM is, After getting this Prompt, i am unable to 
initialize the flash by "fis init -f". The output is pasted below.

RedBoot> fis init -f
About to initialize [format] FLASH image system - continue (y/n)? y
*** Initialize FLASH Image System
... Erase from 0x50040000-0x50fc0000: ..............................Err = a2

   initialization failed 0x50400000: Error trying to erase
... Erase from 0x50fe0000-0x50fe0000:
... Erase from 0x51000000-0x51000000:
... Unlock from 0x50fe0000-0x51000000: .
... Erase from 0x50fe0000-0x51000000: .
... Program from 0x01fdf000-0x01fff000 at 0x50fe0000: Err = 92

Error writing FIS directory at 0x50fe0000: Error trying to program
... Lock from 0x50fe0000-0x51000000: .

                      I have tried to use "fc -i", It also giving the problem 
while programming.

RedBoot> fc -i
Initialize non-volatile configuration - continue (y/n)? y
Run script at boot: false
Use BOOTP for network configuration: true
Console baud rate: 115200
DNS server IP address:
GDB connection port: 9000
Force console for special debug messages: false
Network debug at boot time: false
Default network device: i82559_eth0
Network hardware address [MAC] for NPE eth0: 0x00:0x00:0x84:0x18:0x50:0x02
Network hardware address [MAC] for NPE eth1: 0x00:0x00:0x84:0x40:0x50:0x02
Update RedBoot non-volatile configuration - continue (y/n)? y
... Unlock from 0x50fc0000-0x50fc1000: .
... Erase from 0x50fc0000-0x50fc1000: .
... Program from 0x01fd2000-0x01fd3000 at 0x50fc0000: Err = 92

Error writing config data at 0x50fc0000: Error trying to program
... Lock from 0x50fc0000-0x50fc1000: .


                      Any Input regarding this problem will be appreciated ...     
                      

Thanks & Regards
K.Annamalai Prakash


--
Before posting, please read the FAQ: http://ecos.sourceware.org/fom/ecos
and search the list archive: http://ecos.sourceware.org/ml/ecos-discuss