This is the mail archive of the
ecos-discuss@sourceware.org
mailing list for the eCos project.
Re: RedBoot config parameter mismatch
- From: Gary Thomas <gary at mlbassoc dot com>
- To: Marcello Presulli <m dot presulli at keytronix dot com>
- Cc: ecos-discuss at ecos dot sourceware dot org
- Date: Wed, 09 Aug 2006 08:44:02 -0600
- Subject: Re: [ECOS] RedBoot config parameter mismatch
- References: <94C5430AA547F24AA801BA5706F29D2E0719A0@srvkeyx01.KEYTRONIX.local>
Marcello Presulli wrote:
Hi all,
i have the following situation:
If I run my board (opus103) with the "original" RedBoot loader the
config parameters (fconfig -l) like
baudrate=115200,bootp=true and so on are recognised correctly while
booting,
but when I flash my board with the latest RedBoot loader then the
RedBoot config parameters are not
recognised (e.g. baudrate=9600,bootp=false) even if I reinitialise the
config section with fconfig -i again.
Your description is a bit vague. Maybe you could show the output from
RedBoot which describes the problem you are seeing.
One thing that could be different is that your original version was
built with the fconfig data in a separate FIS image [partition]. The
default is to combine this with the FIS directory. If this is the case,
the new RedBoot will be looking for its fconfig data in a different
place than the old one.
--
------------------------------------------------------------
Gary Thomas | Consulting for the
MLB Associates | Embedded world
------------------------------------------------------------
--
Before posting, please read the FAQ: http://ecos.sourceware.org/fom/ecos
and search the list archive: http://ecos.sourceware.org/ml/ecos-discuss