This is the mail archive of the
ecos-discuss@sourceware.org
mailing list for the eCos project.
Re: redirecting diag_printf - output
- From: Andrew Lunn <andrew at lunn dot ch>
- To: Robert Brusa <bob dot brusa at gmail dot com>
- Cc: ecos-discuss at ecos dot sourceware dot org
- Date: Tue, 9 Sep 2008 15:48:48 +0200
- Subject: Re: [ECOS] redirecting diag_printf - output
- References: <op.ug7uhenekeg3uf@localhost>
On Tue, Sep 09, 2008 at 03:30:44PM +0200, Robert Brusa wrote:
> Hi
> I am "booting" a AT91SAM7X-based board. Previously, with the eval-board,
> diag_printf went to the debug serial interface. The new board does not
> use this interface, instead I would like to assign UART1 to diag_printf.
> I digged into the documentation, but could find now solution to my
> problem. Thanks for an advice.
Take a look at CYGNUM_HAL_VIRTUAL_VECTOR_CONSOLE_CHANNEL. You probably
need to set the value to 1.
Andrew
--
Before posting, please read the FAQ: http://ecos.sourceware.org/fom/ecos
and search the list archive: http://ecos.sourceware.org/ml/ecos-discuss