This is the mail archive of the
ecos-discuss@sourceware.org
mailing list for the eCos project.
Re: FW: Adding flash device using the flash v2 drivers
- From: Gary Thomas <gary at mlbassoc dot com>
- To: Alex Lindeijer <Alex dot L at 3D-Perception dot com>
- Cc: ecos-discuss at sourceware dot org
- Date: Fri, 19 Dec 2008 08:16:42 -0700
- Subject: Re: [ECOS] FW: Adding flash device using the flash v2 drivers
- References: <97F68B92952DDA40A6494655C887603B8DEF8E@nw-ex-004.asplogon.com>
Alex Lindeijer wrote:
> Hi
> We have a controller card with a MPC8541 on it and a spansion S29GL512
> flash. We used the Python eval board from A&M to start the ecos based
> development. The ecos supplied was base don the legacy v1 flash drivers.
> We are experiencing some verification problems on certain higher
> addresses when accessing it from our application but everything is OK
> when writing to flash from Redboot.
Can you give details on this? Can you duplicate the problem
using the Python (A&M MPC8541) board?
--
------------------------------------------------------------
Gary Thomas | Consulting for the
MLB Associates | Embedded world
------------------------------------------------------------
--
Before posting, please read the FAQ: http://ecos.sourceware.org/fom/ecos
and search the list archive: http://ecos.sourceware.org/ml/ecos-discuss