This is the mail archive of the
ecos-discuss@sourceware.org
mailing list for the eCos project.
Re: How to run testprograms for lwip
Robert Brusa wrote:
yes, I see some messages on ser1. It appears every few seconds, but I
get the impression there is no answer comming back. I also hooked my PC
to the LAN with wireshark and there as well, I see nothing originating
from my board.
What are the messages?
tcpecho: When attempting to connect to my board (where tcpecho is
running) with telnet 192.168.0.222 I get the message
telnet: Unable to connect to remote host: No route to host
I guess you configured the IP address statically on your board. Please
make sure that the board is in the same network. For example, if you use
192.168.1.0/24 as your network, you won't be able to ping 192.168.0.222
unless you have defined some routing or a separate IP address in the
192.168.0.0/24 network.
I have the feeling its a hardware problem. The LEDs on the switch I am
connected to with this board also remain dark all the time.
Well, I can't really help you with that. Also, it seems you are using
the current lwip port available in the CVS (or ecos 3.0). I have not
used that port, as it was rather dated, so I ported a newer lwip
version. You could try my port too, a snapshot is available:
http://download.westlicht.ch/lwip-20090722.tar.gz
Simon
--
Before posting, please read the FAQ: http://ecos.sourceware.org/fom/ecos
and search the list archive: http://ecos.sourceware.org/ml/ecos-discuss