This is the mail archive of the
ecos-patches@sourceware.org
mailing list for the eCos project.
[Bug 1001428] Hal bits for Kinetis K40 SLCD controller
- From: bugzilla-daemon at bugs dot ecos dot sourceware dot org
- To: ecos-patches at ecos dot sourceware dot org
- Date: Thu, 22 Dec 2011 08:01:31 +0000
- Subject: [Bug 1001428] Hal bits for Kinetis K40 SLCD controller
- Auto-submitted: auto-generated
- References: <bug-1001428-104@http.bugs.ecos.sourceware.org/>
Please do not reply to this email. Use the web interface provided at:
http://bugs.ecos.sourceware.org/show_bug.cgi?id=1001428
--- Comment #5 from Ilija Kocho <ilijak@siva.com.mk> 2011-12-22 08:01:26 GMT ---
(In reply to comment #4)
> (In reply to comment #3)
> OK. So in the case of the K40 SLCD controller, where would you suggest to place
> this? Looking at the eth/uart drivers, perhaps along the lines of
> /dev/slcd/freescale/<something>, but I am not sure what identifier to assign to
> this actual device.
>
Provided that it doesn't fit in any of existing directories, I would create
directory with general name such as lcd and for device name I would refer to
Freescale docs. That would probably give devs/lcd/freescale/slcd .
Note: I wonder if another tree level would be suitable/desirable such as:
devs/gui/lcd/... Would anybody comment pse?
Ilija
--
Configure bugmail: http://bugs.ecos.sourceware.org/userprefs.cgi?tab=email
------- You are receiving this mail because: -------
You are on the CC list for the bug.