This is the mail archive of the
mailing list for the eCos project.
[Bug 1001219] Ethernet driver for STM32 connectivity line with port on MMstm32f107 board.
- From: bugzilla-daemon at bugs dot ecos dot sourceware dot org
- To: ecos-patches at ecos dot sourceware dot org
- Date: Tue, 09 Apr 2013 12:14:47 +0000
- Subject: [Bug 1001219] Ethernet driver for STM32 connectivity line with port on MMstm32f107 board.
- Auto-submitted: auto-generated
- References: <bug-1001219-104 at http dot bugs dot ecos dot sourceware dot org/>
Please do not reply to this email, use the link below.
--- Comment #61 from Ilija Kocho <firstname.lastname@example.org> ---
(In reply to comment #60)
> Hello Ilija,
> (In reply to comment #59)
> > I was about to commit but in the last check I noticed something that needs
> > explanation.
> > The function hal_stm32x0_led(). I assume there is some conflict with
> > ethernet. Please explain.
> > There must be better solution that deletting 3 leds.
> > 1. Make compilation conditional, so LEDS are in use when possible and
> > ommitted otherwise.
> > 2. Remove this function completely. or replace it with new. (I wouldn't
> > reccommend this).
> > If above assumption is not correct, there may be other solutions as well.
> Sorry I omitted it during checking. This was used by me only for my debug
> purpose. Development board, which I used, has only one LED.
> Please skip this change it's absolutely not needed by driver.
For avoidance of doubt: I revert the code for this function to the state before
adding of Ethernet driver.
You are receiving this mail because:
You are on the CC list for the bug.