This is the mail archive of the
ecos-discuss@sources.redhat.com
mailing list for the eCos project.
Re: Redboot for Excalibur (EPXA10)
- From: Stephan Bourduas <stephan at macs dot ece dot mcgill dot ca>
- To: ecos-discuss at ecos dot sourceware dot org
- Date: Wed, 23 Jun 2004 14:51:50 -0400
- Subject: Re: [ECOS] Redboot for Excalibur (EPXA10)
- References: <45A1F95BB9D7D84FAB0A1EB4D67EEF96A7F9DE@is01ex01.ittiam.com>
- Reply-to: stephan at macs dot ece dot mcgill dot ca
I have a EPXA1 board and I get a similar message when programming through the
JTAG interface. It doesn't seem to cause any problems and I'm able to run
the example programs without any problems. If you don't see anything in
Hyperterminal, you probably don't have it setup right. My redboot image was
compiled to use 57600, but I needed to set Hyperterminal to 115200 to get it
to work.
On June 23, 2004 11:21 am, Vikas K. Prasad wrote:
> Hi,
>
> I was successful in getting the design project 'hello world'
> to work on Altera Excalibur board (EPXA10).
>
> I built redboot.hex using the RAMROM option for this board.
> However, on attempting to burn the flash using the command
> 'exc_flash_programmer -p -v -f -g redboot.hex'
>
> I get the following output (given below).
> I am unable to understand the warning. Also can you help me
> in understanding he address '0xc0000000' that is used to
> create the redboot.hex file from redboot.elf (last step after
> building redboot.elf from configutil).
>
> NOTE: I am not getting the REDBOOT prompt on hyperterminal.
>
> I expected it to be very straightforward. Am I doing something
> fundamentally wrong? Please help me.
>
>
> Altera Excalibur Flash Programmer
> Version 4.0 Build 214 3/25/2004 Service Pack 1 SJ Full Version
> Copyright (C) 1991-2004 Altera Corporation
>
> Using JTAG cable "ByteBlasterII [LPT1]"
> Using Excalibur EPXA10 (device 1 of 4)
> Detected input clock reference at 50.001740MHz
> Using 8MByte device attached to EBI0
> Device is compatible with OEM command set 0003 (typically Intel)
>
> Programming (with verify) offsets 00000000h to 0000d1ffh
> from file: redboot.hex
>
> Percent Complete: 0__________25__________50__________75__________100
> .................................................
>
> Warning: The hex file has specified an non-zero execution start address
> of c7f80040h, which is beyond the maximum offset of 0000d1ffh
>
> Flash programmed and verified successfully
>
> Regards,
> Vikas
--
Before posting, please read the FAQ: http://ecos.sourceware.org/fom/ecos
and search the list archive: http://ecos.sourceware.org/ml/ecos-discuss