This is the mail archive of the
ecos-discuss@sourceware.org
mailing list for the eCos project.
eCos port for Olimex LPC-E2294 development board
- From: Sergei Gavrikov <w3sg at SoftHome dot net>
- To: eCos discuss mail list <ecos-discuss at ecos dot sourceware dot org>
- Date: Fri, 18 Aug 2006 10:46:48 +0300 (EEST)
- Subject: [ECOS] eCos port for Olimex LPC-E2294 development board
Hello
There is an info for the owners of Olimex LPC-E2294 development board.
An eCos port for Olimex LPC-E2294 board (hardware rev. A) is done. A
few days ago I finished a porting RedBoot/eCos for this target. The
port needs no hardware corrections on the board. I heard folks do the
corrections on the board to turn on a 16-bit mode for the Cirrus Logic
CL CS8900A ethernet controller.
There are diagnostic channels support (UART0/UART1/LCD); Intel Flash
parts (TE28F320C3BD70) support; a Cirrus Logic CL CS8900A ethernet
controller (it had been wired in dumb 8-bit mode) support in the port.
Well, the http://sourceware.org/ml/ecos-discuss/2006-07/msg00062.html
problem resolved. There aren't SPI, I2C, CAN, etc. drivers.
The short story how to apply my things to run eCos on the LPC-E2294
development board (note: for recent eCos snapshots) leaves here:
http://sgs.gomel.by/sg/articles/olpce2294/index.html
Any notices about the port are welcome. The port is a pre-released thing :
an olpce2294-1.0.epk ecos package.
Sergei Gavrikov
--
Before posting, please read the FAQ: http://ecos.sourceware.org/fom/ecos
and search the list archive: http://ecos.sourceware.org/ml/ecos-discuss