This is the mail archive of the mailing list for the eCos project.

Index Nav: [Date Index] [Subject Index] [Author Index] [Thread Index]
Message Nav: [Date Prev] [Date Next] [Thread Prev] [Thread Next]
Other format: [Raw text]

RE: initlizing stack for IXP 425 board

Hi all,         

                              We are porting bsp for IXP 425 board using
AXD debugger and
multi-ice(JTAG) which needs debug mode (correct ?).The manual  "Intel(r)
IXP42X Product Line of Network Processors and IXC1100 Control Plane
Processor" , say's that in debug mode does not have a dedicated stack
pointer and following instructions should not be executed in Debug Mode,
they may result in unpredictable behavior LDM ,STM,LDR w/ Rd=PC , LDR w/
RRX addressing mode,  SWP,  LDC,  STC

                              But as part of boot up code  these
instructions ( in reset_vector after PLATFORM_SETUP) Are used like
stmfd, ldmfd.

  Any pointers to resolve this or any sugessitons

Thanks & regards,

The information contained in this electronic message and any attachments to this message are intended for the exclusive use of the addressee(s) and may contain proprietary, confidential or privileged information. If you are not the intended recipient, you should not disseminate, distribute or copy this e-mail. Please notify the sender immediately and destroy all copies of this message and any attachments.

WARNING: Computer viruses can be transmitted via email. The recipient should check this email and any attachments for the presence of viruses. The company accepts no liability for any damage caused by any virus transmitted by this email.

Index Nav: [Date Index] [Subject Index] [Author Index] [Thread Index]
Message Nav: [Date Prev] [Date Next] [Thread Prev] [Thread Next]