About eCos |
Atmel AT91SAM7S-EK Evaluation Board[an error occurred while processing this directive] [an error occurred while processing this directive] The Atmel AT91SAM7S-EK Evaluation Board platform, based on the Atmel AT91SAM7S is supported by RedBoot. [an error occurred while processing this directive] This port is currently considered to be of Alpha quality only at this time. [an error occurred while processing this directive]The support for this platform was contributed to eCos, and the eCos maintainers are grateful on behalf of the open source community to all contributors. Note that some contributed ports may not have been tested. [an error occurred while processing this directive]Supported devicesDevice drivers are included for:
AvailabilityHardware
Atmel development hardware may be obtained by contacting Atmel. Software[an error occurred while processing this directive]Source code for RedBoot is available publically from [an error occurred while processing this directive] the anonymous CVS repository only. Documentation[an error occurred while processing this directive]Specifications are available for the [an error occurred while processing this directive] architecture and [an error occurred while processing this directive] processor and [an error occurred while processing this directive] platform and are available on-line from the manufacturer's web site. [an error occurred while processing this directive]Instructions for installing RedBoot on the at91sam7sT can be found in the RedBoot User's Guide. [an error occurred while processing this directive] Board specific instructions, including installation instructions can be found here within the User's Guide. [an error occurred while processing this directive]Instructions for installing and using eCos on the at91sam7sT are available here. The most recent version of the full documentation set may be found on-line here. [an error occurred while processing this directive]RedBoot supportPrebuilt binaries of RedBoot are available for download for both ROM and RAM startup. Some necessary support files may also be included. Consult the RedBoot documentation on how to use these binaries. ThanksThanks to Oliver Munz and Andrew Lunn who developed this port Also thanks to Ronetix for the loan of a PEEDI JTAG Emulator |